Important points to note

*Connection with aluminum composite cross-linked polyethylene pipes from other companies may cause leakage because the dimensions are different from our pipes. At-joints must be connected to our aluminum composite cross-linked polyethylene pipes. (We will not be responsible for any accidents such as water leakage caused by connection with other companies' pipes. )

*Do not loosen and disassemble the bag nut before connection. We are not responsible for any disassembly.

Do not tighten the nut by grabbing it with a pipe wrench.

*The fittings cannot be reused because the structure is such that the pipes cannot be disconnected once they are connected.

*When connecting with copper pipes to be brazed, braze first and connect the joints after cooling down. Connecting before cooling will cause seizure of the packing, resulting in leakage.

*Before connecting, make sure that no foreign objects enter the inside of the joint.

*Cutting with a copper pipe cutter will cause burrs on the cut surface, resulting in leakage. Be sure to cut with a pipe cutter.

If the tube insertion stops halfway, do not pull it out, but push it in to the normal position.

*If you find a fitting that is significantly difficult to insert the can, discontinue use of that fitting and contact the distributor or us.