Important points to note

*Insulation material may shrink slightly at high temperatures and stretch slightly at low temperatures.

*When joining heat insulator end faces, wrap the joint with heat insulator and finish with tape. Be careful not to roll it too tightly as this may cause condensation.

*After confirming that the brazed part has cooled to the point where it can be touched by hand, insert an appropriate length of insulation material without gaps and repair it with tape.

If a band is tightened on top of the heat-insulating material for vertical or horizontal piping finger support, the heat-insulating material will be crushed and the heat-insulating performance will be lost. Wrap insulation around the support to keep the support out or wrap insulation around the support from the outside.